Wireless sensor network (WSN) is widely used in a variety of applications including habitat monitoring, military surveillance, environmental monitoring, scientific applications, etc. The major limitation of WSN is that sometimes it is not feasible to replace or recharge the battery once it gets fully exhausted and thus, it limits the lifetime of WSN. One of the possible solutions to overcome this limitation is to incorporate any energy harvesting device, which can use the alternative energy sources to charge the battery. However, the processing temperature and the performance of energy harvesting devices limit their applications. In this paper, low temperature and high performance single-sided silicon heterojunction (SHJ) solar cells are fabricated with 13% efficiency using hot-wire chemical vapor deposition (HWCVD) method. This paper also describes an energy management model that successfully addresses the various issues in the existing energy harvesting models. In order to implement the proposed model, the results show that the high efficiency SHJ solar cells are best suitable candidate as an energy harvesting device that can be incorporated inside the node. The subsequent analysis shows that the consumed power per day by the node can be successfully recovered from the SHJ solar cells, if the sunlight is available only for 25 min in a day with 100 mW/cm2 intensity. This clearly indicates that the node's battery will remain fully charged if the above said condition is satisfied, which seems to be very feasible. Finally, one can conclude that the node functioning will remain active till the battery lifetime i.e., approximately 30 years for Li-ion battery.
Skip Nav Destination
Article navigation
August 2018
Research-Article
To Demonstrate the Potential Application of “Low Temperature and High Performance Silicon Heterojunction Solar Cells Fabricated Using HWCVD” in Wireless Sensor Network: An Initial Research
Mohit Agarwal,
Mohit Agarwal
Department of Electronics and
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Search for other works by this author on:
Amit Munjal,
Amit Munjal
Department of Electronics and
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Search for other works by this author on:
Rajiv Dusane
Rajiv Dusane
Semiconductor Thin Film and
Plasma Processing Laboratory,
Department of Metallurgical Engineering and
Materials Science,
Indian Institute of Technology Bombay,
Mumbai 400076, India
Plasma Processing Laboratory,
Department of Metallurgical Engineering and
Materials Science,
Indian Institute of Technology Bombay,
Mumbai 400076, India
Search for other works by this author on:
Mohit Agarwal
Department of Electronics and
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Amit Munjal
Department of Electronics and
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Communication Engineering,
Thapar University,
Patiala 147004, Punjab, India
Rajiv Dusane
Semiconductor Thin Film and
Plasma Processing Laboratory,
Department of Metallurgical Engineering and
Materials Science,
Indian Institute of Technology Bombay,
Mumbai 400076, India
Plasma Processing Laboratory,
Department of Metallurgical Engineering and
Materials Science,
Indian Institute of Technology Bombay,
Mumbai 400076, India
Contributed by the Solar Energy Division of ASME for publication in the JOURNAL OF SOLAR ENERGY ENGINEERING: INCLUDING WIND ENERGY AND BUILDING ENERGY CONSERVATION. Manuscript received November 3, 2017; final manuscript received February 15, 2018; published online March 13, 2018. Assoc. Editor: Geoffrey T. Klise.
J. Sol. Energy Eng. Aug 2018, 140(4): 041002 (5 pages)
Published Online: March 13, 2018
Article history
Received:
November 3, 2017
Revised:
February 15, 2018
Citation
Agarwal, M., Munjal, A., and Dusane, R. (March 13, 2018). "To Demonstrate the Potential Application of “Low Temperature and High Performance Silicon Heterojunction Solar Cells Fabricated Using HWCVD” in Wireless Sensor Network: An Initial Research." ASME. J. Sol. Energy Eng. August 2018; 140(4): 041002. https://doi.org/10.1115/1.4039427
Download citation file:
Get Email Alerts
Cited By
A Combined Computational and Mathematical Analysis of Interconnect Fatigue Potential in Photovoltaic Modules
J. Sol. Energy Eng (August 2025)
Computational Fluid Dynamics Analysis of an Office With Seated Persons and a Double-Duct Solar Roof Chimney for Passive Ventilation
J. Sol. Energy Eng (August 2025)
Energy Efficiency and Grid-Independent Buildings
J. Sol. Energy Eng (October 2025)
Related Articles
Measured Performance of Building Integrated Photovoltaic Panels—Round 2
J. Sol. Energy Eng (August,2005)
ASME Solar Energy Division 2001 Graduate Student Award
J. Sol. Energy Eng (August,2001)
RIE-Texturing of Industrial Multicrystalline Silicon Solar Cells
J. Sol. Energy Eng (February,2005)
Harvesting Wind Energy Using a Galloping Piezoelectric Beam
J. Vib. Acoust (February,2012)
Related Proceedings Papers
Related Chapters
Micro Sensor Node for Real Time Indoor Temperature Monitoring
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Mass Data Processing Optimization on High Energy Physics Experiments
International Conference on Advanced Computer Theory and Engineering, 4th (ICACTE 2011)
Hydro Tasmania — King Island Case Study
Energy and Power Generation Handbook: Established and Emerging Technologies