The emphasis on lightweight large-caliber weapons systems has placed the focus on the use of advanced composite materials. Using composite materials not only directly removes weight from the gun tube but, by better balancing the tube, allows the use of smaller gun stabilization drive systems, thus further enhancing system weight loss. Additionally, the use of high stiffness composites helps with pointing accuracy and alleviating the dynamic strain phenomenon encountered with high-velocity projectiles. Traditionally though, using composites has been difficult because of the coefficient of thermal expansion mismatch between the steel substrate and the composite jacket, which causes a gap after manufacturing. Dealing with this mismatch has greatly complicated the manufacturing process in the past to the point where mass-producing the barrels would be problematic at best. By using a thermoplastic resin and a cure on the fly process, the manufacturability of the barrels has been greatly improved and the gap has been eliminated. This is the first time that this approach has been applied to a large-caliber gun tube. A barrel has been manufactured using this process with IM7 fibers in a polyetheretherketone matrix and successfully test fired. This paper will present the design, manufacturing, and test firing of this barrel.
Skip Nav Destination
e-mail: andrew.littlefield@us.army.mil
Article navigation
Research Papers
Carbon Fiber/Thermoplastic Overwrapped Gun Tube
Andrew Littlefield,
e-mail: andrew.littlefield@us.army.mil
Andrew Littlefield
U.S. Army RDECOM-ARDEC Benét Laboratories
, Watervliet, NY 12189
Search for other works by this author on:
Robert Becker
Robert Becker
Search for other works by this author on:
Andrew Littlefield
U.S. Army RDECOM-ARDEC Benét Laboratories
, Watervliet, NY 12189e-mail: andrew.littlefield@us.army.mil
Edward Hyland
Andrew Andalora
Nathaniel Klein
Robert Langone
Robert Becker
J. Pressure Vessel Technol. May 2006, 128(2): 257-262 (6 pages)
Published Online: January 5, 2006
Article history
Received:
December 12, 2005
Revised:
January 5, 2006
Citation
Littlefield, A., Hyland, E., Andalora, A., Klein, N., Langone, R., and Becker, R. (January 5, 2006). "Carbon Fiber/Thermoplastic Overwrapped Gun Tube." ASME. J. Pressure Vessel Technol. May 2006; 128(2): 257–262. https://doi.org/10.1115/1.2172958
Download citation file:
Get Email Alerts
The Behavior of Elbow Elements at Pure Bending Applications Compared to Beam and Shell Element Models
J. Pressure Vessel Technol (February 2025)
Related Articles
120 mm Prestressed Carbon Fiber/Thermoplastic Overwrapped Gun Tubes
J. Pressure Vessel Technol (August,2012)
The Conception of the Segmented Kinetic Energy Penetrators for Tank Guns
J. Appl. Mech (September,2010)
Development of an Engineering Model for Predicting the Transverse Coefficients of Thermal Expansion of Unidirectional Fiber Reinforced Composites
J. Eng. Mater. Technol (July,2009)
Thermomechanically Controlled Erosion in Army Cannons: A Review
J. Pressure Vessel Technol (May,2006)
Related Chapters
Strain Hardening and Tensile Properties
New Advanced High Strength Steels: Optimizing Properties
Research on Strengthening Mechanism of Plant Root in Slope Protection
Geological Engineering: Proceedings of the 1 st International Conference (ICGE 2007)
Thermoelastic Expansion of Graphite-Epoxy Unidirectional and Angle-Ply Composites
Composite Reliability