The knowledge of thermal transport characteristics is of primary importance in the application of foams. The thermal characteristics of a foam heavily depend on its microstructure and, therefore, have to be investigated at a pore level. However, this analysis is a challenging task, because of the complex geometry of a foam. The use of foam models is a promising tool in their study. The Kelvin and the Weaire–Phelan foam models, among the most representative practical foam models, are used in this paper to numerically investigate heat transfer and pressure drop in metallic foams. They are developed in the “surface evolver” open source software. Mass, momentum, and energy equations, for air forced convection in open cell foams, are solved with a finite-element method, for different values of cell size and porosity. Heat transfer and pressure drop results are reported in terms of volumetric Nusselt number and Darcy–Weisbach friction factor, respectively. Finally, a comparison between the numerical predictions obtained with the two foam models is carried out, in order to evaluate the feasibility to substitute the more complex and computationally heavier Weaire–Phelan foam structure with the simpler Kelvin foam representation. Negligible differences between the two models are exhibited at high porosities.
Lord Kelvin and Weaire–Phelan Foam Models: Heat Transfer and Pressure Drop
Contributed by the Heat Transfer Division of ASME for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received January 7, 2015; final manuscript received July 16, 2015; published online October 21, 2015. Assoc. Editor: Antonio Barletta.
- Views Icon Views
- Share Icon Share
- Search Site
Cunsolo, S., Iasiello, M., Oliviero, M., Bianco, N., Chiu, W. K. S., and Naso, V. (October 21, 2015). "Lord Kelvin and Weaire–Phelan Foam Models: Heat Transfer and Pressure Drop." ASME. J. Heat Transfer. February 2016; 138(2): 022601. https://doi.org/10.1115/1.4031700
Download citation file: