New methods of removing surface contaminants from microelectronic and microelectromechanical systems (MEMS) devices are needed since the decreasing size of their components is reducing the allowable contamination levels. By choosing the pulse duration and fluence to optimize electronic rather than thermal desorption in short-pulse laser processing, surface species can be removed without exceeding maximum temperature constraints. A two-temperature model for short-pulse laser heating of, and subsequent desorption from, metal surfaces is presented. A scaling analysis indicates the material properties and laser parameters on which the ratio of electronic to thermal desorption depends. Regimes of predominantly electronic and thermal desorption are identified, and predicted desorption yields from gold films show that electronic desorption is the primary desorption mechanism in certain short-pulse laser processes.
Skip Nav Destination
Article navigation
Research Papers
Electronic Desorption of Surface Species Using Short-Pulse Lasers
L. M. Phinney,
L. M. Phinney
Department of Mechanical Engineering, University of California, Berkeley, CA 94720-1740
Search for other works by this author on:
Chang-Lin Tien
Chang-Lin Tien
Department of Mechanical Engineering, University of California, Berkeley, CA 94720-1740
Search for other works by this author on:
L. M. Phinney
Department of Mechanical Engineering, University of California, Berkeley, CA 94720-1740
Chang-Lin Tien
Department of Mechanical Engineering, University of California, Berkeley, CA 94720-1740
J. Heat Transfer. Aug 1998, 120(3): 765-771 (7 pages)
Published Online: August 1, 1998
Article history
Received:
July 16, 1997
Revised:
April 23, 1998
Online:
December 5, 2007
Citation
Phinney, L. M., and Tien, C. (August 1, 1998). "Electronic Desorption of Surface Species Using Short-Pulse Lasers." ASME. J. Heat Transfer. August 1998; 120(3): 765–771. https://doi.org/10.1115/1.2824348
Download citation file:
Get Email Alerts
Cited By
Challenges and Innovations of Lithium-Ion Battery Thermal Management Under Extreme Conditions: A Review
J. Heat Mass Transfer (August 2023)
Related Articles
An Integral Equation for the Dual-Lag Model of Heat Transfer
J. Heat Transfer (October,2004)
Stimuli-Responsive Triblock Polymers for Multipulse Drug Delivery
J. Med. Devices (June,2009)
Thermal Analysis of Solids at High Peclet Numbers Subjected to Moving Heat Sources
J. Heat Transfer (February,1999)
The Measurement of Transient Two-Dimensional Profiles of Velocity and Fuel Concentration Over Liquids
J. Heat Transfer (May,1999)
Related Proceedings Papers
Related Chapters
Design of System Integration and Interface of Laser Engraving Machine
International Conference on Advanced Computer Theory and Engineering, 5th (ICACTE 2012)
Improvement of Wear Resistance of Steel by Means of a Cavitating Jet and a Submerged Pulse Laser
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Laser Induced Breakdown and Bubble Cavitation
Proceedings of the 10th International Symposium on Cavitation (CAV2018)