Many electronics cooling applications involve direct air cooling of the components and their heat transfer performance is often estimated, in the design phase, using heat transfer coefficient data from either in-house data or published sources. The agreement between predicted and observed system performance is quite often not acceptable, which means that the cooling system must be developed empirically—an expensive and time-consuming process. The authors believe they have identified one important reason for this state of affairs: the heat transfer coefficient values presented in the literature are being used improperly. Almost all of the published heat transfer coefficient data are from single-active-component experiments, which implicitly define h based on the adiabatic temperature of the component (had), while most users assume h to be defined on the basis of the mean fluid temperature (hm). This misunderstanding leads to underpredictions of the temperature rise of the components by 20–30 percent or more. This paper reviews the options for defining the heat transfer coefficient, shows how the problem arises, and then describes the steps necessary to properly use the existing heat transfer coefficient data base. There are two options for applying the existing data base to a fully powered array: One can either calculate the adiabatic temperatures of the components from the known heat release distribution in the array or calculate the values of hm that can be used with Tm, again using the known heat release distribution. The two options represent different ways to apply the same general method, superposition. The superposition method of Sellars, et al., (1956) is adapted to discrete systems and used as a guide to the forms recommended.
Skip Nav Destination
Article navigation
Research Papers
Applying Heat Transfer Coefficient Data to Electronics Cooling
R. J. Moffat,
R. J. Moffat
Department of Mechanical Engineering, Stanford University, Stanford, CA 94305
Search for other works by this author on:
A. M. Anderson
A. M. Anderson
Department of Mechanical Engineering, Stanford University, Stanford, CA 94305
Search for other works by this author on:
R. J. Moffat
Department of Mechanical Engineering, Stanford University, Stanford, CA 94305
A. M. Anderson
Department of Mechanical Engineering, Stanford University, Stanford, CA 94305
J. Heat Transfer. Nov 1990, 112(4): 882-890 (9 pages)
Published Online: November 1, 1990
Article history
Received:
February 21, 1989
Revised:
February 22, 1990
Online:
May 23, 2008
Citation
Moffat, R. J., and Anderson, A. M. (November 1, 1990). "Applying Heat Transfer Coefficient Data to Electronics Cooling." ASME. J. Heat Transfer. November 1990; 112(4): 882–890. https://doi.org/10.1115/1.2910495
Download citation file:
Get Email Alerts
Cited By
Entropic Analysis of the Maximum Output Power of Thermoradiative Cells
J. Heat Mass Transfer
Molecular Dynamics Simulations in Nanoscale Heat Transfer: A Mini Review
J. Heat Mass Transfer
Related Articles
Direct Air Cooling of Electronic Components: Reducing Component Temperatures by Controlled Thermal Mixing
J. Heat Transfer (February,1991)
Confined and Submerged Liquid Jet Impingement Heat Transfer
J. Heat Transfer (November,1995)
A Correlation for Heat Transfer and Wake Effect in the Entrance Region of an In-Line Array of Rectangular Blocks Simulating Electronic Components
J. Heat Transfer (February,1995)
A Vapotron Effect Application for Electronic Equipment Cooling
J. Electron. Packag (December,2003)
Related Proceedings Papers
Related Chapters
Introduction
Thermal Management of Microelectronic Equipment
Thermal Design Guide of Liquid Cooled Systems
Thermal Design of Liquid Cooled Microelectronic Equipment
Fans and Air Handling Systems
Thermal Management of Telecommunications Equipment