Natural gas is traditionally considered as a promising fuel in comparison with gasoline due to the potential of lower emissions and significant domestic reserves. These emissions can be further diminished by using noble gases, such as argon, instead of nitrogen as the working fluid in internal combustion engines. Furthermore, the use of argon as the working fluid can increase the thermodynamic efficiency due to its higher specific heat ratio. In comparison with premixed operation, the direct injection of natural gas enables the engine to reach higher compression ratios while avoiding knock. Using argon as the working fluid increases the in-cylinder temperature at top dead center (TDC) and enables the compression ignition (CI) of natural gas. In this numerical study, the combustion quality and ignition behavior of methane injected into a mixture of oxygen and argon have been investigated using a three-dimensional transient model of a constant volume combustion chamber (CVCC). A dynamic structure large eddy simulation (LES) model has been utilized to capture the behavior of the nonpremixed turbulent gaseous jet. A reduced mechanism consists of 22-species, and 104-reactions were coupled with the CFD solver. The simulation results show that the methane jet ignites at engine-relevant conditions when nitrogen is replaced by argon as the working fluid. Ignition delay times are compared across a variety of operating conditions to show how mixing affects jet development and flame characteristics.
Skip Nav Destination
Article navigation
August 2019
Research-Article
A Computational Investigation of Nonpremixed Combustion of Natural Gas Injected Into Mixture of Argon and Oxygen
Martia Shahsavan,
Martia Shahsavan
Department of Mechanical Engineering,
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
e-mail: martia_shahsavan@student.uml.edu
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
e-mail: martia_shahsavan@student.uml.edu
1Corresponding author.
Search for other works by this author on:
Mohammadrasool Morovatiyan,
Mohammadrasool Morovatiyan
Department of Mechanical Engineering,
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
Search for other works by this author on:
J. Hunter Mack
J. Hunter Mack
Department of Mechanical Engineering,
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
Search for other works by this author on:
Martia Shahsavan
Department of Mechanical Engineering,
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
e-mail: martia_shahsavan@student.uml.edu
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
e-mail: martia_shahsavan@student.uml.edu
Mohammadrasool Morovatiyan
Department of Mechanical Engineering,
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
J. Hunter Mack
Department of Mechanical Engineering,
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
University of Massachusetts Lowell,
One University Avenue,
Lowell, MA 01854
1Corresponding author.
Manuscript received March 12, 2019; final manuscript received March 19, 2019; published online April 11, 2019. Editor: Jerzy T. Sawicki.
J. Eng. Gas Turbines Power. Aug 2019, 141(8): 081011 (7 pages)
Published Online: April 11, 2019
Article history
Received:
March 12, 2019
Revised:
March 19, 2019
Citation
Shahsavan, M., Morovatiyan, M., and Mack, J. H. (April 11, 2019). "A Computational Investigation of Nonpremixed Combustion of Natural Gas Injected Into Mixture of Argon and Oxygen." ASME. J. Eng. Gas Turbines Power. August 2019; 141(8): 081011. https://doi.org/10.1115/1.4043277
Download citation file:
Get Email Alerts
Cited By
Shape Optimization of an Industrial Aeroengine Combustor to reduce Thermoacoustic Instability
J. Eng. Gas Turbines Power
Dynamic Response of A Pivot-Mounted Squeeze Film Damper: Measurements and Predictions
J. Eng. Gas Turbines Power
Review of The Impact Of Hydrogen-Containing Fuels On Gas Turbine Hot-Section Materials
J. Eng. Gas Turbines Power
Effects of Lattice Orientation Angle On Tpms-Based Transpiration Cooling
J. Eng. Gas Turbines Power
Related Articles
Ignition Delay and Combustion Characteristics of Gaseous Fuel Jets
J. Eng. Gas Turbines Power (April,2010)
Alternative Fuels Based on Biomass: An Investigation of Combustion Properties of Product Gases
J. Eng. Gas Turbines Power (March,2013)
Ignition and Flame Speed Kinetics of Two Natural Gas Blends With High Levels of Heavier Hydrocarbons
J. Eng. Gas Turbines Power (February,2010)
A Comprehensive Model for the Auto-Ignition Prediction in Spark Ignition Engines Fueled With Mixtures of Gasoline and Methane-Based Fuel
J. Eng. Gas Turbines Power (April,2019)
Related Proceedings Papers
Related Chapters
Lay-Up and Start-Up Practices
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Studies Performed
Closed-Cycle Gas Turbines: Operating Experience and Future Potential