Chemical-Looping Combustion (CLC) is a process where fuel oxidation is carried out through an intermediate agent—a metal oxide—circulated across two fluidized bed reactors: a reduction reactor, where an endothermic reaction reduces the metal oxide and oxidizes the fuel, and an oxidation reactor, where an exothermic reaction oxidizes the metal oxide in air. Overall, the system carries out the same job of a conventional combustor, with the fundamental advantage of segregating the oxidation products and into an output flow free of nitrogen and excess oxygen. The flow exiting the reduction reactor consists of water and the latter readily available for liquefaction, transport and long-term storage. The hot, vitiated air from the oxidation reactor is the means to produce power through a thermodynamic cycle. This paper reports of a study supported by the ENI group to assess the potential of the integration between CLC and combined gas-steam power cycles. More specifically, we focus on four issues: (i) optimization of plant configuration; (ii) prediction of overall efficiency; (iii) use of commercial gas turbines; (iv) preliminary economic estimates. The CLC system is based on iron oxides which, to maintain their physical characteristics, must operate below 900–1000°C. Given the crucial importance of the temperature of the vitiated air generated by CLC on the performance of the combined cycle, we consider two options: (i) “unfired” systems, where natural gas is fed only to the CLC system, (ii) “fired” systems, where the vitiated air is supplementary fired to reach gas turbine inlet temperatures ranging 1000–1200°C. Results show that unfired configurations with maximum process temperature 850–1050°C and zero emissions reach net LHV plant efficiencies ranging 43%–48%. Fired cycles where temperature is raised from 850 to 1200°C by supplementary firing can achieve 52% net LHV efficiency with emission about one half of those of a state-of-the-art combined cycles. Fired configurations allow significant capital cost and fuel cost savings compared to unfired configurations; however, a carbon tax high enough to make them attractive (close to 50 €/ton) would undermine these advantages.
Skip Nav Destination
Article navigation
July 2006
Technical Papers
Chemical-Looping Combustion for Combined Cycles With CO2 Capture
Giovanni Lozza,
Giovanni Lozza
Dipartiamento di Energetica, Politecnico di Milano, Milan, Italy
Search for other works by this author on:
Giampaolo Pelliccia,
Giampaolo Pelliccia
Dipartiamento di Energetica, Politecnico di Milano, Milan, Italy
Search for other works by this author on:
Stefano Rossini,
Stefano Rossini
Enitecnologie, San Donato Milanese, Milan, Italy
Search for other works by this author on:
Francesco Saviano
Francesco Saviano
Enitecnologie, San Donato Milanese, Milan, Italy
Search for other works by this author on:
Stefano Consonni
Giovanni Lozza
Dipartiamento di Energetica, Politecnico di Milano, Milan, Italy
Giampaolo Pelliccia
Dipartiamento di Energetica, Politecnico di Milano, Milan, Italy
Stefano Rossini
Enitecnologie, San Donato Milanese, Milan, Italy
Francesco Saviano
Enitecnologie, San Donato Milanese, Milan, Italy
Contributed by the International Gas Turbine Institute (IGTI) of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Paper presented at the International Gas Turbine and Aeroengine Congress and Exhibition, Vienna, Austria, June 13–17, 2004, Paper No. 2004-GT-53503. Manuscript received by IGTI, October 1, 2003; final revision, March 1, 2004. IGTI Review Chair: A. J. Strazisar.
J. Eng. Gas Turbines Power. Jul 2006, 128(3): 525-534 (10 pages)
Published Online: June 13, 2006
Article history
Received:
October 1, 2003
Revised:
March 1, 2004
Online:
June 13, 2006
Citation
Consonni, S., Lozza , G., Pelliccia, G., Rossini , S., and Saviano, F. (June 13, 2006). "Chemical-Looping Combustion for Combined Cycles With CO2 Capture ." ASME. J. Eng. Gas Turbines Power. July 2006; 128(3): 525–534. https://doi.org/10.1115/1.1850501
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Natural Gas Decarbonization to Reduce CO 2 Emission From Combined Cycles—Part II: Steam-Methane Reforming
J. Eng. Gas Turbines Power (January,2002)
Analysis of Gas-Steam Combined Cycles With Natural Gas Reforming and CO 2 Capture
J. Eng. Gas Turbines Power (July,2005)
Comparative Study of Two Low C O 2 Emission Power Generation System Options With Natural Gas Reforming
J. Eng. Gas Turbines Power (September,2008)
Natural Gas Decarbonization to Reduce CO 2 Emission From Combined Cycles—Part I: Partial Oxidation
J. Eng. Gas Turbines Power (January,2002)
Related Chapters
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential