Before and during World War II, the design and development of single stage high pressure ratio centrifugal compressors was essentially a cut-and-try exercise. To reach a high pressure without substantial experimentation required multiple stages of impellers and diffusers with pressure ratios in the 2:1 range. While such arrangements were satisfactory for commercial use where weight was not a major consideration, they were not suitable for jet engines. The centrifugal compressor for the Whittle engine, the first British jet engine, was developed by trial and error with numerous modifications of the hub-shroud profile. The centrifugal compressor section of the National Advisory Committee for Aeronautics (NACA) designed, built, and tested three compressor impellers during and after World War II. They were part of a program designed to evaluate various blade shapes, but encountered such instabilities at the design pressure ratios that the experimental results led to no definitive conclusions. In 1948, the Centrifugal Compressor Section was given the assignment to further investigate the three impellers. The investigation led to the development of a quasi-three-dimensional design procedure that eliminated the guesswork from the basic design of a centrifugal impeller. Since the 1948 to 1955 time period over which the procedure was developed, the advances in computers have allowed refinements in the original computational methods. It is the objective of this presentation to review the history of the NACA centrifugal compressor program and efforts that have led to the latest developments in computational design procedures.
Skip Nav Destination
Article navigation
January 2005
Technical Papers
A Review of the History of the National Advisory Committee for Aeronautics Centrifugal Compressor Program and Arrival at Current Computational Design Procedures
Joseph T. Hamrick
Joseph T. Hamrick
Aerospace Research Corporation, 5454 Aerospace Road, Roanoke, VA 24014
Search for other works by this author on:
Joseph T. Hamrick
Aerospace Research Corporation, 5454 Aerospace Road, Roanoke, VA 24014
Contributed by the Fluids Engineering Division for publication on the JOURNAL OF FLUIDS ENGINEERING. Manuscript received by the Fluids Engineering Division August 25, 2004; revised manuscript received September 7, 2004. Review Conducted by: Y. Tsujimoto.
J. Fluids Eng. Jan 2005, 127(1): 94-97 (4 pages)
Published Online: March 22, 2005
Article history
Received:
August 25, 2004
Revised:
September 7, 2004
Online:
March 22, 2005
Citation
Hamrick, J. T. (March 22, 2005). "A Review of the History of the National Advisory Committee for Aeronautics Centrifugal Compressor Program and Arrival at Current Computational Design Procedures ." ASME. J. Fluids Eng. January 2005; 127(1): 94–97. https://doi.org/10.1115/1.1855326
Download citation file:
212
Views
Get Email Alerts
Cited By
Related Articles
Numerical Optimization of a Vaned Shroud Design for Increased
Operability Margin in Modern Centrifugal Compressors
J. Turbomach (October,2006)
Effect of Impeller Blade Loading on Compressor Stage Performance in a High Specific Speed Range
J. Turbomach (July,2012)
Novel IGV Designs for Centrifugal Compressors and Their Interaction With the Impeller
J. Turbomach (March,2012)
Analysis and Validation of a Unified Slip Factor Model for Impellers at Design and Off-Design Conditions
J. Turbomach (October,2011)
Related Proceedings Papers
Related Chapters
Introduction
Design and Analysis of Centrifugal Compressors
Boundary Layer Analysis
Centrifugal Compressors: A Strategy for Aerodynamic Design and Analysis
Introduction
Mixed-flow Pumps: Modeling, Simulation, and Measurements