Numerous studies have shown that the minimization of entropy generation does not always lead to an optimum performance in energy conversion systems. The equivalence between minimum entropy generation and maximum power output or maximum thermal efficiency in an irreversible power cycle occurs subject to certain design constraints. This article introduces specific entropy generation defined as the rate of total entropy generated due to the operation of a power cycle per unit flowrate of fuel. Through a detailed thermodynamic modeling of a gas turbine cycle, it is shown that the specific entropy generation correlates unconditionally with the thermal efficiency of the cycle. A design at maximum thermal efficiency is found to be identical to that at minimum specific entropy generation. The results are presented for five different fuels including methane, hydrogen, propane, methanol, and ethanol. Under identical operating conditions, the thermal efficiency is approximately the same for all five fuels. However, a power cycle that burns a fuel with a higher heating value produces a higher specific entropy generation. An emphasis is placed to distinguish between the specific entropy generation (with the unit of J/K mol fuel) and the entropy generation rate (W/K). A reduction in entropy generation rate does not necessarily lead to an increase in thermal efficiency.
Skip Nav Destination
Article navigation
March 2018
Research-Article
Specific Entropy Generation in a Gas Turbine Power Cycle
Y. Haseli
Y. Haseli
School of Engineering and Technology,
Central Michigan University,
Mount Pleasant, MI 48859
Central Michigan University,
Mount Pleasant, MI 48859
Search for other works by this author on:
Y. Haseli
School of Engineering and Technology,
Central Michigan University,
Mount Pleasant, MI 48859
Central Michigan University,
Mount Pleasant, MI 48859
Contributed by the Advanced Energy Systems Division of ASME for publication in the JOURNAL OF ENERGY RESOURCES TECHNOLOGY. Manuscript received July 12, 2017; final manuscript received August 28, 2017; published online September 28, 2017. Editor: Hameed Metghalchi.
J. Energy Resour. Technol. Mar 2018, 140(3): 032002 (8 pages)
Published Online: September 28, 2017
Article history
Received:
July 12, 2017
Revised:
August 28, 2017
Citation
Haseli, Y. (September 28, 2017). "Specific Entropy Generation in a Gas Turbine Power Cycle." ASME. J. Energy Resour. Technol. March 2018; 140(3): 032002. https://doi.org/10.1115/1.4037902
Download citation file:
Get Email Alerts
Cited By
Numerical Study of Composite Percussive Drilling With Consideration of Heat Transfer Between Drilling Fluid and Bottom-Hole Rock in Geothermal Drilling
J. Energy Resour. Technol (June 2023)
An Investigation of the Impact of Combustion Chamber Geometry on Turbulent Burning Speeds in a Thermodynamic Model
J. Energy Resour. Technol (June 2023)
Synergy in Syngas Yield From Co-Pyrolysis of Cow and Chicken Manures
J. Energy Resour. Technol (June 2023)
Related Articles
Gas Turbine Cycles With Solid Oxide Fuel Cells—Part I: Improved Gas Turbine Power Plant Efficiency by Use of Recycled Exhaust Gases and Fuel Cell Technology
J. Energy Resour. Technol (December,1994)
Generation of Complex Energy Systems by Combination of Elementary Processes
J. Energy Resour. Technol (November,2018)
150 kwe Supercritical Closed Cycle System
J. Eng. Power (January,1971)
Thermoelectric Generation from Exhaust Heat in Electrified Natural Gas Trucks: Modeling and Analysis of an Integrated Engine System Performance Improvement
J. Energy Resour. Technol (January,0001)
Related Chapters
Thermodynamic Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Physiology of Human Power Generation
Design of Human Powered Vehicles