Simulations and physical robots have shown that hopping and running are possible without sensory feedback. However, stable behavior is often limited to a certain range of the parameters of the open-loop system. Even the simplest of hopping systems can exhibit unstable behavior that results in unpredictable nonperiodic motion as system parameters are adjusted. This paper analyzes the stability of a simplified vertical hopping model driven by an open-loop, feedforward motor pattern. Periodic orbits of the resulting hybrid system are analyzed through a generalized formula for the system’s Poincare Map and Jacobian. The observed behavior is validated experimentally in a physical pneumatically actuated hopping machine. This approach leads to observations on the stability of this and similar systems, revealing inherent limitations of open-loop hopping and providing insights that can inform the design and control of dynamic legged robots capable of rapid and robust locomotion.
Skip Nav Destination
e-mail: jgcham@robotics.caltech.edu
Article navigation
Technical Papers
Dynamic Stability of Open-Loop Hopping
Jorge G. Cham,
Jorge G. Cham
Center for Design Research,
e-mail: jgcham@robotics.caltech.edu
Stanford University
, Stanford, CA 94305-2232
Search for other works by this author on:
Mark R. Cutkosky
Mark R. Cutkosky
Center for Design Research,
Stanford University
, Stanford, CA 94305-2232
Search for other works by this author on:
Jorge G. Cham
Center for Design Research,
Stanford University
, Stanford, CA 94305-2232e-mail: jgcham@robotics.caltech.edu
Mark R. Cutkosky
Center for Design Research,
Stanford University
, Stanford, CA 94305-2232J. Dyn. Sys., Meas., Control. May 2007, 129(3): 275-284 (10 pages)
Published Online: September 21, 2006
Article history
Received:
September 8, 2004
Revised:
September 21, 2006
Citation
Cham, J. G., and Cutkosky, M. R. (September 21, 2006). "Dynamic Stability of Open-Loop Hopping." ASME. J. Dyn. Sys., Meas., Control. May 2007; 129(3): 275–284. https://doi.org/10.1115/1.2718237
Download citation file:
Get Email Alerts
Vibration Suppression based on Improved Adaptive Optimal Arbitrary-Time-Delay Input Shaping
J. Dyn. Sys., Meas., Control
Fault Detection of Automotive Engine System Based on Canonical Variate Analysis Combined With Bhattacharyya Distance
J. Dyn. Sys., Meas., Control (July 2025)
Related Articles
An Approach to Identify Joint Motions for Dynamically Stable Walking
J. Mech. Des (May,2006)
Search for Initial Conditions for Sustained Hopping of Passive Springy-Leg Offset-Mass Hopping Robot
J. Dyn. Sys., Meas., Control (July,2007)
Biped RCCR Mechanism
J. Mech. Des (March,2009)
The Computation of All 4R Serial Spherical Wrists With an Isotropic Architecture
J. Mech. Des (June,2003)
Related Proceedings Papers
Related Chapters
QP Based Encoder Feedback Control
Robot Manipulator Redundancy Resolution
Fault-Tolerant Control of Sensors and Actuators Applied to Wind Energy Systems
Electrical and Mechanical Fault Diagnosis in Wind Energy Conversion Systems
Parameter Estimation of the Duffing Oscillator Using Poincaré Map and an Elitist Genetic Algorithm
Intelligent Engineering Systems through Artificial Neural Networks, Volume 20