This paper presents an optimal solution to the problem of tracking controller design for a category of direct-drive robot arms, mechanically constructed to have invariant and decoupled joint actuator dynamics. The controller acts on joint actuators consisting of d.c. servo motors driven via servo amplifiers containing an analog current feedback loop. For good tracking behavior, the controller uses future reference positions of a joint to anticipate the changes in reference velocity. An explicit acceleration feedforward term is avoided improving the power to noise ratio of the control signal. For good regulation behavior, the controller uses position and velocity feedback. An integral of error term is also avoided, reducing the probability of the occurrence of limit cycle oscillations caused by saturation of the actuator torque rating. The correlations between the classical and the optimal design parameters are discussed using transient response analysis followed by experimental observations.
Optimal Tracking Controller Design for Invariant Dynamics Direct-Drive Arms
- Views Icon Views
- Share Icon Share
- Search Site
Pak, H. A., and Turner, P. J. (December 1, 1986). "Optimal Tracking Controller Design for Invariant Dynamics Direct-Drive Arms." ASME. J. Dyn. Sys., Meas., Control. December 1986; 108(4): 360–365. https://doi.org/10.1115/1.3143807
Download citation file: