... - LN2) machining and at two different hybrid cooling/lubricating conditions. In the orthogonal turning tests performed, three different cutting speeds and a constant undeformed chip thickness were used as cutting parameters. During orthogonal machining experiment, cutting force components were measured...

... is also low (1.025) under the same cutting conditions of minimum cutting forces. A good correlation exists between the thrust force vs. delamination factor (> 0.85) and the delamination factor vs. AE RMS signal (> 0.80) for the selected cutting environments. The recommended range of RMS voltage...

..., it is found that both tool rake angle and depth of cut affect the morphologies of the formed chips, and as well as the cutting force evolution during machining process. Second, the normal residual stress in the tangential direction is more significant and has a clearer pattern than those in other directions...

... Tool/chip interface on tool rake face is also called the first shear zone in machining processes. The interaction between tool rake face and formed chip greatly affects chip morphology, cutting forces, and other phenomena observed in machining. However, the interaction at nanometric scale has...

... acoustic emission (AE) and cutting forces signals to predict entrance and exit burrs size in slot milling operation. These models can help estimating the burrs size without having to measure them. The machining tests were carried on Al 7075-T6 aluminum alloy using 3 levels of cutting speed, 3 levels...

..., the cutting force and surface roughness are compared when machining alumina with RUM method and with conventional diamond drilling method. Furthermore, the effects of the control variables (rotational speed, feed rate, and ultrasonic power) on RUM outputs (such as cutting force and surface roughness...

... been reported for machining them, no reports can be found in the literature on rotary ultrasonic machining of titanium alloys. This paper presents an experimental study on rotary ultrasonic machining of a titanium alloy. The tool wear, cutting force, and surface roughness when rotary ultrasonic...