An engine test facility, capable of being operated with different nozzles, has been developed. The shape of this component has evolved substantially, over the years, from seemingly simple circular geometries to very complex geometries designed to address different requirements. There are numerous test facilities that facilitate an extensive standalone component level testing of these components. However, such testing does not offer an insight into the effect these complex geometries will have on the performance of a gas turbine engine. This facility will serve as a demonstration for graduate and doctoral students, enhancing their understanding of engine performance.

The core of the test facility is a single spool turbojet engine from AMT, Netherlands. The engine is instrumented with pressure and temperature measurements at every inter-component location. A conventional intake duct is designed, for measurement of air flow rate. The entire engine is mounted on a 6-axis force measurement device, for measurement of thrust during engine operations. Towards the rear of the engine, a straight duct is attached after the jet pipe, on which any new nozzle can be retrofitted to the engine. To address changes in operating conditions when using different nozzles, the engine is equipped with a suitably designed bleed duct, which is attached onto the jet pipe.

The engine, successfully integrated with all the components, has been subjected to multiple tests at different power settings. The first test was done using the baseline engine, operated at various rotor speeds. The next test was done with a custom nozzle having an area ratio of 2, attached to the jet pipe. Owing to the successful design of the components, the engine performance was measured when operated with a smaller area nozzle.

This content is only available via PDF.
You do not currently have access to this content.