0
Technical Brief

Combined Heat and Power Plant and District Heating and Cooling Network: A Test-Case in Italy With Integration of Renewable Energy

[+] Author and Article Information
Paolo Sdringola

Department of Engineering,
University of Perugia,
via G. Duranti 93,
Perugia 06125, Italy
e-mail: paolo.sdringola@unipg.it

Stefania Proietti

Department of Sustainability Engineering,
Guglielmo Marconi University,
via Plinio 44,
Rome 00193, Italy
e-mail: s.proietti@unimarconi.it

Davide Astolfi

Department of Engineering,
University of Perugia,
via G. Duranti 93,
Perugia 06125, Italy
e-mail: davide.astolfi@unipg.it

Francesco Castellani

Professor
Department of Engineering,
University of Perugia,
via G. Duranti 93,
Perugia 06125, Italy
e-mail: francesco.castellani@unipg.it

1Corresponding author.

Contributed by the Solar Energy Division of ASME for publication in the JOURNAL OF SOLAR ENERGY ENGINEERING: INCLUDING WIND ENERGY AND BUILDING ENERGY CONSERVATION. Manuscript received August 29, 2017; final manuscript received April 26, 2018; published online June 18, 2018. Assoc. Editor: Jorge Gonzalez.

J. Sol. Energy Eng 140(5), 054502 (Jun 18, 2018) (8 pages) Paper No: SOL-17-1356; doi: 10.1115/1.4040196 History: Received August 29, 2017; Revised April 26, 2018

The 2012 European energy efficiency directive supported the development of cogeneration combined heat and power (CHP) and district heating and cooling (DHC) networks, stressing the benefits of a more efficient energy supply, the exploitation of recovered heat, and renewable resources, in terms of fuel consumption and avoided costs/emissions. Policy decisions play a crucial role: technical and environmental feasibility of CHP is clear and well demonstrated, whereas economic issues (fuel prices, incentives, etc.) may influence its actual application. In this framework, the introduction of low-carbon technologies and the exploitation of renewable energies are profitable interventions to be applied on existing plants. This work focuses on a small CHP plant, installed in the 90 s and located within a research facility in Italy, designed to supply electricity and heat/cool through a district network. On the basis of monitored consumption of electricity, heating, and cooling, energy fluxes have been analyzed and an assessment was performed to get a management profile enhancing both operational and economic parameters. The integration of renewable energies, i.e., solar-powered systems for supporting the existing devices, has been evaluated, thus resulting in a hybrid trigeneration plant. Results demonstrate how the useful synergy between CHP and DHC can not only be profitable from the economic point of view, but it can also create conditions to considerably boost the integral deployment of primary energy sources, improving fuel diversity and then facing the challenge of climate change toward sustainable energy networks in the future.

FIGURES IN THIS ARTICLE
<>
Copyright © 2018 by ASME
Your Session has timed out. Please sign back in to continue.

References

Ackermann, T. , Andersson, G. , and Söder, L. , 2001, “ Distributed Generation: A Definition,” Electr. Power Syst. Res., 57(3), pp. 195–204. [CrossRef]
IEA, 2014, Linking Heat and Electricity Systems. Co-Generation and District Heating and Cooling Solutions for a Clean Energy Future Electricity Information, International Energy Agency, Paris, France.
IEA, 2009, Energy Policies of IEA Countries: Spain 2009 Review, International Energy Agency, Paris, France
Rezaie, B. , and Rosen, M. A. , 2012, “ District Heating and Cooling: Review of Technology and Potential Enhancements,” Appl. Energy, 93, pp. 2–10. [CrossRef]
IEA, 2009, Cogeneration and District Energy, International Energy Agency, Paris, France.
Kavvadias, K. C. , Tosios, A. P. , and Maroulis, Z. B. , 2010, “ Design of a Combined Heating, Cooling and Power System: Sizing, Operation Strategy Selection and Parametric Analysis,” Energy Convers. Manage., 51(4), pp. 833–845. [CrossRef]
European Parliament and the Council, 2012, “ Directive 2012/27/EU of the European Parliament and of the Council of 25 October 2012 on Energy Efficiency Amending Directives 2009/125/EC and 2010/30/EU and Repealing Directives 2004/8/EC and 2006/32/EC,” Off. J. Eur. Union, 315, pp. 1–56.
United States Government, 2012, Executive Order 13624: Accelerating Investment in Industrial Energy Efficiency, Federal Register, Washington, DC.
National Development and Reform Commission, 2011, “Guiding Opinions on the Deployment of Gas‐Fired Distributed Energy,” Ministry of Finance, Ministry of Housing and Urban-Rural Development, National Energy Administration, Government of China, Beijing, China.
Energy and Environment Council, 2012, “Innovative Strategy for Energy and the Environment,” Government of Japan, Tokyo, Japan.
Melloni, L. , and Altobelli, C. , 2015, “ CHP Plant Revamping Project. A Promising Energy Efficiency Story in the Industry Sector,” Energy Procedia, 82, pp. 599–606. [CrossRef]
Stanek, W. , Gazda, W. , and Kostowski, W. , 2015, “ Thermo-Ecological Assessment of CCHP (Combined Cold-Heat-and-Power) Plant Supported With Renewable Energy,” Energy, 92(3), pp. 279–289. [CrossRef]
GSA, 2015, “ National Assessment for the Potential of High Efficiency Combined Heat and Power and District Heating in Italy,” Gestore dei Servizi Energetici (GSE), Rome, Italy.
Government of Italy, 2014, “ Italian Energy Efficiency Action Plan 2014,” Government of Italy, Rome, Italy.
Ricardo Energy & Environment on Behalf of the Department for Energy and Climate Change, 2015, “National Comprehensive Assessment of the Potential for Combined Heat and Power and District Heating and Cooling in the UK,” Government of UK, London.
Wang, J. , Yang, Y. , Mao, T. , Sui, J. , and Jin, H. , 2015, “ Life Cycle Assessment (LCA) Optimization of Solar-Assisted Hybrid CCHP System,” Appl. Energy, 146, pp. 38–52. [CrossRef]
Zeyghami, M. , Goswami, D. Y. , and Stefanakos, E. , 2015, “ A Review of Solar Thermo-Mechanical Refrigeration and Cooling Methods,” Renewable Sustainable Energy Rev., 51, pp. 1428–1445. [CrossRef]
Reda, F. , Viot, M. , Sipilä, K. , and Helm, M. , 2016, “ Energy Assessment of Solar Cooling Thermally Driven System Configurations for an Office Building in a Nordic Country,” Appl. Energy, 166, pp. 27–43. [CrossRef]
IEA, 2012, Technology Roadmap. Solar Heating and Cooling, International Energy Agency, Paris, France.
Chidambaram, L. A. , Ramana, A. S. , Kamaraj, G. , and Velraj, R. , 2011, “ Review of Solar Cooling Methods and Thermal Storage Options,” Renewable Sustainable Energy Rev., 15(6), pp. 3220–3228. [CrossRef]
Desideri, U. , Proietti, S. , and Sdringola, P. , 2009, “ Solar-Powered Cooling Systems: Technical and Economic Analysis on Industrial Refrigeration and Air-Conditioning Applications,” Appl. Energy, 86(9), pp. 1376–1386. [CrossRef]
Intelligent Energy Europe, 2009, “ Removal of Non-Technological Barriers to Solar Cooling Technology Across Southern European Islands,” Intelligent Energy Europe, Brussels, Belgium, SOLCO Project No. EISAS/EIE/06/116/2006. https://ec.europa.eu/energy/intelligent/projects/en/projects/solco

Figures

Grahic Jump Location
Fig. 1

Electricity from cogeneration by source in 2013

Grahic Jump Location
Fig. 2

Thermal energy supplied by DHC by sector in 2013

Grahic Jump Location
Fig. 4

Heat recovery equipment

Grahic Jump Location
Fig. 5

Overall CCHP system diagram

Grahic Jump Location
Fig. 6

CHP/DHC layout the power station is the colored box on the right, the substations are all the others

Grahic Jump Location
Fig. 7

Hourly power consumption by different time bands

Grahic Jump Location
Fig. 8

Daily heating left and right bars and cooling center bars demand

Grahic Jump Location
Fig. 9

Economic comparative assessment

Tables

Errata

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In